Alyseum MS-MATRIX User Manual download pdf (Page 7)

MS-MATRIX – User’s manual © - Revision 1.5

Page 7

5 Software

5.1 Initialization Sequence

1. Turn the Eurorack case power on

2. The brand name Alyseum is displayed on the LED array for less than a second

3. The three mode LEDs flash for half a second each

4. The matrix stored in the last used Preset is loaded and displayed

on the LED array.

5. A MIDI signal is sent via IR, informing slave modules that the

particular Preset has been loaded.

5.2 Mode Selection

Push the Mode button to select the desired mode

● No Mode (All LED Mode Off)

● IN / OUT

● PRESET

● MIDI / CV

5.3 IN / OUT Mode

To select a connection between an input and an output on the matrix:

1. Select IN/OUT Mode (see paragraph 5.2)

2. The line and column guides appear on the LED array.

3. Turn the INPUT/SAVE encoder to select a row.

The selected row number corresponds to the input jack of the same number

4. Turn the OUTPUT/LOAD encoder to select a column.

5. The selected column number corresponds to the output jack of the same number

To activate the selected connection push either the INPUT/SAVE or the OUTPUT/LOAD

encoder until the corresponding LED is turned ON. The line and column guides disappear.

To deactivate the selected connection push either the INPUT/SAVE or OUTPUT/LOAD

encoder until the corresponding LED is turned OFF. The line and column guides disappear

To move on to another connection, turn the INPUT/SAVE or the OUTPUT/LOAD encoder

and then go to step 4 .

The MS-MATRIX does NOT function as a mixer. Please refer to the expander for mixer

function.

While it is possible to map one input location to several output locations (and thus have the

MS-MATRIX act as a multiplier), it is impossible to map several inputs to the same output.

IN / OUT

PRESET

MIDI / CV

No Mode

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Alyseum MS-MATRIX User Manual Page 7