Alyseum MS-MATRIX User Manual download pdf (Page 10)

MS-MATRIX – User’s manual © - Revision 1.5

Page 10

If your keyboard range is too short, the lowest key which will correspond to Preset 01 can

be reassigned:

1. Make sure you have your MIDI keyboard properly connected to the MIDI IN input of

the MS-MATRIX

2. Turn the Eurorack case power off.

3. Push and hold the push button while turning the Eurorack case power back on.

4. NEW NOTE is displayed on the LED display

5. Release the Mode push button (Mode button)

6. Press the desired key on your MIDI keyboard (Note On), hold it for at least 5 seconds

or wait for the MIDI/CV LED to flash 4 times and then release the key (Note Off).

7. The MIDI/CV Mode LED flashes 4 times and the new lowest Note is saved.

8. The initialization sequence is begins (see paragraph 5.1)

There is no need to repeat this operation every time you turn the module on, since the

lowest Note is stored in the non-volatile memory of the module.

In step 6, if more than one keys are simoultaneously pressed for more than 5 seconds,

only the one pressed earlier will be used for setting the new lowest key for Preset 01.

5.6.2 Setting Auto Save or Manual Save

To change the method Presets are saved:

1. Turn the Eurorack case power off.

2. Push and hold the INPUT/SAVE encoder while

turning the Eurorack case power back on.

3. Release the encoder.

4. Turn the OUTPUT/LOAD encoder to choose

between AUTO SAVE and MAN. SAVE as indicated on the LED display.

5. Push the OUTPUT/LOAD encoder to confirm your selection.

6. The Initialization sequence begins (see paragraph 5.1)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

No comments

Alyseum MS-MATRIX User Manual Page 10